Kverneland Disc coulters bearings

Plow Parts according to brand
(1182)

Manure and grassland skimmers to brand
(170)

Coulters NIAUX to fit
(20)

Disc coulters bearings according to brand
(7)

Welding points
(4)

Accessories for plow parts
(13)

Agrolux Disc coulters bearings
(2)

Kverneland Disc coulters bearings
(3)

Massey Ferguson Disc coulters bearings
(2)

Rabe Disc coulters bearings
(1)

Överum Disc coulters bearings
(3)
Deep groove ball bearing for coulters compl. with shaft Ø30mm
Part-no. | 31-L16 |
Weight | 3.400 kg |
Pitch circle diameter | Ø100 |
Accessories
Part fitting for machine…
No original parts. Manufacturer's designations and original parts numbers are provided for comparison purposes only. The dimensions and weights are approximate and non-binding. Subject to technical changes.
Bearing without cap piece of the bearing with shaft Ø34mm
Part-no. | 31-L17 |
Weight | 2.090 kg |
Pitch circle diameter | Ø80 |
Attention!! | The bearing is delivered without grease lubrication! |
Important notice: | |
Important notice 1 | The hub 31-L17 is a hub designed plow coulters. As such, it is not designed to absorb lateral forces, and is suited only for straight directions of drive. |
Important notice 2 | The hub 31-L17 contains a needle bearing which is supported, closed and sealed on both sides by the housing and the hub cap. For this reason, a maximum of only one dose of grease may be applied into the hub. Otherwise, damage may occur in the hub. |
Accessories
Part fitting for machine…
No original parts. Manufacturer's designations and original parts numbers are provided for comparison purposes only. The dimensions and weights are approximate and non-binding. Subject to technical changes.
Bearing without cap piece of the bearing with shaft Ø30mm
Part-no. | 31-L17A |
Weight | 1.920 kg |
Pitch circle diameter | Ø80 |
Attention!! | The bearing is delivered without grease lubrication! |
Accessories
Part fitting for machine…
No original parts. Manufacturer's designations and original parts numbers are provided for comparison purposes only. The dimensions and weights are approximate and non-binding. Subject to technical changes.
Unauthorized use of any of the drawings is a violation of copyright and will be prosecuted. The registrated trademark has been placed in our illustrations solely to protect them as part of our intellectual property.